hit-air Wearble Airbag
Home LINE UP System Manual FAQ Contact About us
hit-air manual
????

1
2
Reassembly following Activation1 Make a hexagon wrench and a setting bolt (screw) ready.
Reassembly following Activation2 Unscrew the used gas cartridge and remove all remaining gas from the airbag.
3
4
Reassembly following Activation3 Insert a setting bolt into the key box and tighten up by hand.
Then tighten further with the hexagon wrench.
(Then the hole for the key ball goes down)
Reassembly following Activation4 Tighten or loosen the hexagon wrench until the hole for the key ball is placed at the center of the hole of the key box.
5
6
Reassembly following Activation5 Then insert the key ball ring rightly and deeply into the hole of the key box.
(Press down the ring by the fingernail)
Reassembly following Activation6 Lower the red guard over the hole and remove the setting bolt.
(Y type has no red guard) Caution- If the red guard does not come down,
it means that the key ball is not set properly.
Use the setting bolt or fingernails for further adjustment until the key ball is settled down completely.
7
8
Reassembly following Activation7 Lift the red guard after the setting bolt is removed.
(Y type has no red guard) Caution- If the red guard remains down over the key ball in the hole,
it will block the key ball coming out and the airbag will not inflate.
The red guard of the key box should always be up.
Reassembly following Activation8 Screw an unused gas cartridge fully into the bottom until it cannot go any further.
Caution- If the gas cartridge is not screwed tightly,
the gas may leak through a loose screw and the airbag may not inflate in full.
9
Reassembly following Activation9 Close the zipper to cover the key box.

The end of Re-assembly.
 


hit-air Mugen Denko Co., Ltd.
1-1012,Ikeba,Tempaku-ku,Nagoya,
468-0055,Japan
mugen@hit-air.com Copyright: (C) 2003 MUGENDENKO
All Rights Reserved.